There is also the rear speaker 'bar' which also has a couple of cubbies in it. Automotive wiring in a 2008 Nissan 350Z vehicles are becoming increasing more difficult to identify due to the installation of more advanced factory oem electronics. Erm, well that setup's not really within my budget which is about £80 or so. I'll try and get some pics up of my install when I get time to upload them as the boot section is almost finished now!! Check out our for details. Other options for your 350Z Here are some other ways to improve your 350Z: iPod® adapter If you want to keep your factory stereo, but would like to add iPod control, there is an iPod adapter available for the Nissan 350Z.
Pull the subwoofer clear and disconnect the wiring harness. This is because of the reclined dashboard. Lift the rubber seal from the side panel. This car audio wiring guide will identify each speaker wire by color and location. There is plenty of space for racking amps behind the seat.
This will involve you removing the center console and shifter. Disconnect the wiring harness and remove the speaker. The navigation system found in the 350Z Crutchfield Research Photo With navigation Replacing the stereo in vehicles with the factory navigation system is the same as the non-nav system. She's worked on cars for even longer doing paint and body, accessory installations, custom interior work, engine building, tuning and more. Oh is the Bose amp a big size?? Pry off the plastic front panel on the door pull handle, and remove two 10mm bolts bolts underneath it. . This will generate a better sound than 6.
Its funny u responed to this cuz i wanted to ask u if you had any specs on the box you mad i wanted to make the same one on the opposite side of yours. A closeup of the 350Z's rear deck speakers Crutchfield Research Photo To get to the rear speakers, start at the scuff plates at the bottom of the door frame. Subscribe for more automative tips! Presented here is one path to attaining that goal, but you can approach the project in just about any order. If you want to start by adding more bass, then install a new subwoofer first. Remove the four Phillips screws two on the right side and two on the left holding the receiver to the trim panel, and set the panel aside. Installing new speakers also requires mounting brackets which are available at a discount when you purchase your speakers from Crutchfield.
Tools needed: Phillips screwdriver, panel tool Removing the rear deck speakers is a bit challenging Crutchfield Research Photo Rear speakers Replacing the rear speakers is not as simple as replacing those in the doors. Start at the back edge and pull toward you away from the dash. This will release the metal clips securing the panel. Any reliance you place on such information is therefore strictly at your own risk. Oh and if your Zed has the Bose set up then you should have a factory Bose amp for running the sub. I should have photographed them--sorry. Most complete stereo kits come with an replacement dash panel, which gives you 350Z the appearance that your aftermarket stereo came from the factory.
Set the speaker assembly aside and drill the new holes. When all clips are loose, remove the side panels. Go Fast Have Fun make no representations or warranties of any kind, express or implied, about the completeness, accuracy, reliability, suitability or availability with respect to the Video or the information, products, services, or related graphics contained on the Video for any purpose. Wiring in an aftermarket amplifier is made easy with the rear panels, which can be removed for mounting. Take a look below for our comprehensive Nissan 350Z wiring guide. Once loose, roll the panel toward the back of the car and remove the four Phillips head screws securing the speaker. This thread has a fairly detailed description of both front and rear installs, all the info is there.
Nissan 350Z Roadster Crutchfield Research Photo Good, better, best Upgrading the audio system in your 350Z requires some careful planning, namely due to the limited space available in the doors and cargo area. Only the rear speakers and the subwoofer. Some related threads for ideas: Post n 14 in this thread might be what you're after?! The information in this Video presents guidelines to help vehicle enthusiasts modify or repair their vehicles and to demonstrate what car culture is all about. Take advantage of that easy-to-get-to tweeter location by installing a component speaker system in the doors. Do not pull too far — the panel is connected by wires, and you will need to disconnect those before removing the panel completely. Whether your an expert Nissan 350Z mobile electronics installer, Nissan 350Z fanatic, or a novice Nissan 350Z enthusiast with a 2008 Nissan 350Z, a car stereo wiring diagram can save yourself a lot of time. Disconnect both of these and remove the panel and the receiver completely.
Again, using Posi-Product wire taps will let you do the job without cutting off the Nissan connectors. Pretty easy as long as you're a little brave pulling off the snap in connectors. Our guide begins with the 2003 model year for the Nissan 350Z. All I really want to do is balance out the sound in the car so that it isn't all coming from the front. The Nissan 350Z will require a flip up stereo that comes with an adjustable angle.
Or did you mean actually in the glove box!!? Leave them for us below! While upgrading the fronts might be a bit more difficult than the rears you will get a much better improvement. Avoid alpine ones - Alpine make really good head units but their other audio components are not in the same league bar the F1 stuff. This included changes to the stereo wiring as well. To install your new receiver, simply repeat these steps in reverse. I'm looking at replacing the rear speakers in my non-Bose zed with some decent replacements that you can actually hear. Nothing presented should be relied upon you for your modification or repair plans for your vehicle and is not in any way professional mechanical advice. The amp is hiding under that.